No. 04 (2022) Volume02 Issue04

In medical practice, for the prevention and treatment of various diseases, anti-inflammatory, antimicrobial and regenerative herbal medicines are widely used. The healing properties of medicinal plants are due to active or pharmacologically active substances - alkaloids, glycosides, saponins, tannins, enzymes, vitamins, hormones, phytoncides, etc. They are the most valuable, although they are contained in plants in minimal quantities. The article presents the results of obtaining a bactericidal, wound-healing ointment based on a dry extract of celandine herb, propolis and sea buckthorn oil.

Consumed by sheep for digestion of nutrients the physical condition, type, and age of the sheep also have a significant effect. The age of the sheep Depending on the level of digestion of nutrients in lambs from 120 to 200 days. In the digestive organs the gradual process of digestion of proteins, carbohydrates and fats and foods that are relatively high in fiber with low fiber digestibility reduction facilitates digestion.

This paper presents the results of using solar energy for drying lumber and wood in different countries: Canada, Russia, Poland, Finland, Bulgaria, and Syria. Also described is an innovative solar dryer for drying lumber developed at the Ferghana Polytechnic Institute at the Department of Ground Vehicles and Their Operation.

This article presents the results of studies on the importance of the fermentation process in cheese production, the type of enzyme, and the effect of the amount of enzyme on the yield of finished cheese after pressing. The article mainly provides information on the effect of three enzymes Fromase 220 TL, Lot F6073, DSM Food Specialties, SG -50 and Maxiren 1800, Lot R 5664, DSM Food Specialties on the amount of finished cheese at the output, including the same amount of enzymes in the amount of 1 .25 g per 100 kg of the mass of the mixture.

This article discusses the use of information technology in higher education and the organization of the educational process on this basis, the development of pedagogical principles for the process of creating a distance e-learning course and the formation of practical skills.

The study of the effect of nickel on dimethylglyoxime from the composition of adsorbents used in this article showed that the optimal conditions for this are graphically determined using a spectrophotometer. The analysis was detected in a photocolorimeter.

This article discusses the analysis of the general equations of the transverse vibration of a piecewise homogeneous viscoelastic plate obtained in the “Oscillation of bilayer plates of constant thickness”.

The article discusses methods of sowing cotton in horizontal and vertical planes. The most effective method of seeding – square-nesting-is justified and recommendations are given for the wide use of this method. To obtain a square-nesting cotton crop, it is planned to create a new mechanism in the design of the seeder.

The article provides knowledge and skills on the rational use of equipment of machine tools, a single system of pre-scheduled repairs to extend the service life of metal cutting machines, an inspection of machines, wear of parts and components and modern methods of their restoration, the formation of appropriate knowledge, skills and competencies. In particular, at present, the enterprises producing parts for the local automotive industry, operating in the regions of the Republic, produce products on large press tandem lines and small press machines. Thousands of expensive press moulds are imported from the world's largest machine-building companies, and their maintenance and repair processes are very expensive for localized companies. If there are small defects, problems or repairs in the parts of the press moulds, it is necessary to carry out urgent repair of the mould with the participation of the enterprise and the main manufacturer. There is a solution to the problem of forming the current and capital repairs of small and large press-moulding equipment, the restoration and production of parts and other elements.